SHINELCO TELECOMANDO UNIVERSALE MANUALE CODE
DIRECT PROGRAMMING The code to program your device can be identified in the BRAND CODES sections of this instruction, looking for the brand or, if you know the exact brand and model, through research on line on the website, or even by downloading the electronic catalogue from the website. The device key DTT/SAT emits a flash to confirm that the code that is acquiring will be memorised on the DTT/SAT benchģ. Press now the OK button in the middle of the cruise to start being the process of receiving from the monitor. Simultaneously pressing the device key DTT / SAT in the upper right and the red button (A) in the lower left corner and release: The transparent device keys are flashing. If you want to program X-Light 2 for a satellite device, digital terrestrial, follow the above procedure whereas paragraph 3 varies as follows: Note: If you notice a single and prolonged flash, it means that there has been an error and you must repeat the procedure from the beginning For each device to be commanded you must repeat this procedure.
Now slip off the batteries from their slot, enter them again after a few seconds and close the battery case compartment The procedure is finished: The transparent device keys emit again 3 confirmation flashes. Programming can be considered successfully completed when the transparent device keys start flashing regularly intermittent (see Note). Now bring near the remote to his image in the web page and pressing the button START PROGRAMMING Throughout the whole programming phase the transparent device keys will flash continuously but unevenly (asynchronous) to indicate progress of code acquisition state The remote must be hold down in front of the screen.
SHINELCO TELECOMANDO UNIVERSALE MANUALE TV
The device key TV emits a flash to confirm that the code that is acquiring will be memorised on the TV bench. Release: The selection keys are flashing.
Simultaneously pressing the Device key TV in the upper left and the red button (A) in the lower left. For example, suppose you want to program X-Light for a TVĬonnect to the web site dedicated to this product, enter the Catalogue and select Brand and Model of the TV you want to program (the model can be found on the instruction booklet or on the back or side of the device).Īfter inserting the batteries and found the 3 flashes of the transparent device keys left open the battery case compartment during the entire procedure.
NEW COMPUTER PROGRAMMING (valid only for X Light version) This innovative system patented by Visa Electronics lets you program and operate in few seconds the new remote X-Light, choosing from more than 500,000 models of devices available in the catalogue that are constantly updated with news that occur in the market. The transparent Device keys will emit 3 flashes to indicate that X-Light/X-Wire is ready to be programmed. Open the cover of the battery compartment on the back of the remote and insert the batteries with special attention to respect the polarity. BATTERY INSTALLATION The X-LIGHT/X-WIRE works with 2, 1,5 volts LR03 type mini batteries.
0 kommentar(er)
